HP StorageWorks D2D Backup System Instructions for Installing Disks in a Replacement (EH923-90902, September 2007)

Installing the hard disks in the replacement unit
1. Remove the access cover, front bezel and drive cover from the replacement unit, as described in
steps 2 to 4 of ”Removing the hard disks and tape drive from the failed unit” on page 5.
2. Observing normal anti-static precautions, install the disks you have just removed in the
replacement unit. The disks may be installed in any order.
1. Slide each hard disk drive into the appropriate bay until it clicks into place.
2. Connect the power cable from the power supply to the back of the hard disk drive.
Figure 8 Installing a hard disk drive