HP StorageWorks D2D Backup System Instructions for Installing Disks in a Replacement (EH923-90902, September 2007)

HP StorageWorks D2D Backup System 15
6. Install the tape drive.
1. Slide the tape drive most of the way into the device bay.
2. Attach a spare power cable from the server’s internal power supply to the power connector
on the tape drive. Connect the device cable (SCSI or SAS) to the appropriate ports on the
HBA and tape drive.
Figure 16 Installing an internal tape drive (example shows a SCSI tape drive)
7. Slide the tape drive fully into the bay until it is seated securely.
8. If you have installed an internal tape drive, remove the blank plate (1) at the top of the bezel.
Figure 17 Removing plate for internal drive (optional)