HP StorageWorks D2D Backup System Instructions for Installing Disks in a Replacement (EH923-90902, September 2007)

Installing a replacement HP D2D Backup System16
Replacing the bezel and access panel
1. Replace the bezel.
1. Insert the two hooks on the right side of the bezel into the rectangular holes on the chassis.
2. Rotate the bezel into place so that the three tabs on the left side of the bezel snap into the
slots on the chassis.
Figure 18 Replacing the bezel (no tape drive installed)
2. Replace the access panel.
1. Use two hands to place the access panel flat against the chassis, the back of the access
panel extending about 2.5 cm (1.0 in) behind the back of the server. Make sure the hooks
on the access panel align with the holes on the edges of the chassis.
2. Slide the access panel toward the front of the chassis to position it into place.
3. Tighten the captive thumbscrew to secure the access panel.
Figure 19 Replacing the access panel (no tape drive installed)