HP StorageWorks D2D Backup System Instructions for Installing Disks in a Replacement (EH923-90902, September 2007)

HP StorageWorks D2D Backup System 5
Removing the hard disks and tape drive from the failed unit
1. Disconnect the network cable and the power cord from the failed HP D2D Backup System.
2. If there is an external tape drive connected, make sure that it is switched off and disconnect the
power and device cables from the HP D2D Backup System.
3. Remove the access panel on the failed HP D2D Backup System.
1. Loosen the captive thumbscrew located on the rear edge of the access panel.
2. Slide the panel back about 2.5 cm (1.0 in).
Figure 1 Removing the access panel