HP StorageWorks D2D Backup System Instructions for Installing Disks in a Replacement (EH923-90902, September 2007)

Installing a replacement HP D2D Backup System6
4. Remove the front bezel.
1. Press in on the two bottom tabs on the side of the bezel so that they release from the chassis.
2. Press in on the upper tab on the side of the bezel so that it releases from the chassis. The
bezel will rotate out slightly.
3. Pull the bezel away from the front panel.
Figure 2 Removing the front bezel
5. Remove the cover that secures the drives so that you can remove the hard disk drives.
1. Remove the screw.
2. Pull the cover up and away from the drives.
Figure 3 Removing the drive cover