HP StoreOnce B6200 Installation Planning and Preparation Guide (EJ022-90995, November 2013)

Figure 8 Template 3 cabling to customer's networks
bonded 10 GbE ports to customer's data and management network1 and 2
See Factory default cabling (page 12). These should not be disconnected.light blue cables
Template 4, uses two 1GbE networks
Template 4 supports users who have two 1GbE networks. One 1 GbE network is used for data;
the other is used for management. The gateway must be in the same sub-net as the network that
is being used to connect to remote sites. This is normally the data path sub-net, for example used
for remote/external site replication traffic.
The default bonding mode for this template is Mode 1 on both sub-nets.
The recommended IP address range is 25 in total: 16 contiguous on the data sub-net; 1 + 8
contiguous on the management sub-net.
Figure 9 Template 4 cabling to customer's networks
bonded 1 GbE ports to customer's management sub-net1 and 3
bonded 1 GbE ports to customer's data sub-net2 and 4
See Factory default cabling (page 12). These should not be disconnected.light blue cables
Template 5, uses 1GbE network only
For software revision 3.3.0 and greater: Template 5 supports users who want to have only two
1GbE network connections from each node in a couplet to their Ethernet switches. The same network
is used for data and management. It is primarily for customers who only use VTL as their backup
targets and do not use StoreOnce Catalyst stores or NAS CIFS/NFS shares. VTL replication jobs
will still run over the Ethernet connections.
The default bonding mode for this template is Mode 1 on both sub-nets.
The recommended IP address range is 17 in total: 1 for management and 16 contiguous for data.
18 Connecting to your network