HP StoreOnce B6200 Installation Planning and Preparation Guide (EJ022-90995, November 2013)

Please enter networking parameters below. They are required for the network configuration script.7.

1. All templates:

Virtual Management Console VIF IP address, recommended to be the first address in your

contiguous IP range..............................................................................................

2. Templates 1 and 4 only, Management sub-net parameters

If provided, must be on same sub-net as Virtual Management Console VIF

Start IP adress......................................................................................................

End IP address (must be contiguous)..................................................................................

Netmask....................................................................................................................

3. All templates, Data sub-net parameters

Start IP adress............................................................................................................

End IP address (must be contiguous)...............................................................................

Netmask.........................................................................................................................

4. Domain name (optional).............................................................................................

5. All templates:

Gateway IP address

.....................................................................................................................

Templates 1 and 4 only:

Second gateway IP address.......................................................................................

Which gateway to act as 'default'............................................................................

6. DNS server IP address(es) .................................................................................

up to three......................................................................................................................

IMPORTANT: Your HP service specialist will provide you with a record of the Virtual IP addresses

after the network configuration has been completed. These are the addresses that you need to

connect to the B6000 Management Console (from the GUI or CLI) and to configure backup and

replication targets.

Do you have sufficient physical network connections for your template (see also table below)?8.

1. Number of switches per network.................................................................

(The recommendation is for two switches for each network to which you are connecting.)

2. Number of physical ports available:

1GbE..............................................................

10GbE..............................................................

Physical network connections

The installation requires the following physical network connections to the rack(s). See also Physical

Ethernet connection requirements (page 20).

4321Number of couplets

16 x 10GbE

12 x 10GbE

8 x 10GbE

4 x 10GbE

Template 1

16 x 1GbE12 x 1GbE8 x 1GbE4 x 1GbE

32 x 1GbE24 x 1GbE16 x 1GbE8 x 1GbETemplate 2

16 x 10GbE12 x 10GbE8 x 10GbE4 x 10GbETemplate 3

32 x 1GbE24 x 1GbE16 x 1GbE8 x 1GbETemplate 4

16 x 1GbE12 x 1GbE8 x 1GbE4 x 1GbETemplate 5

Network requirements 29