HP StoreOnce Enterprise Manager User Guide

3 Configuring the HP StoreOnce Enterprise Manager
To start using the HP StoreOnce Enterprise Manager, the administrator must configure it by
performing the following procedures in this order:
1. “Adding a device” (page 13)
2. “Adding new users, administrators, and groups” (page 16)
3. “Creating a new group” (page 16)
Other optional configuration steps include:
• “Importing an AD group” (page 20)
• “Setting up SMTP for emailed reports” (page 23)
• “Configuring a report scheduler” (page 25)
NOTE: Only an administrator can perform these procedures. Users with user-level permissions
cannot add a device, add new users, or create groups.
Adding a device
HP StoreOnce systems monitored by the HP StoreOnce Enterprise Manager are referred to as
devices. Before adding a device to the HP StoreOnce Enterprise Manager, update the device
firmware to the most recent version.
Four types of devices exist:
• Gen2, single node, refers to HP StoreOnce 250x, 41xx, and 43xx series devices.
• Gen3, single node, refers to HP StoreOnce 26xx, 27xx, 42xx, 44xx, 45xx, 47xx, and 49xx
devices.
• Gen3, multi-node, refers to HP StoreOnce B6200 and 6500 devices.
• HP StoreOnce VSA series
The procedure to add devices differs slightly between Gen2 and Gen3 devices.
To add devices:
1. From the Administration section of the Navigation tree, select Device Management.
2. Click Add.
The Add Device dialog box appears.
3. Select the appropriate radio button to determine how the HP StoreOnce Enterprise Manager
will locate the device, and then type the correct information into the corresponding field.
Adding a device 13