HP StoreOnce Enterprise Manager User Guide

7. Click OK to continue.
If the operation fails, an error dialog box appears. Click OK to close the dialog box, then
repeat this procedure.
If the device discovery operation fails after multiple attempts, check the network connectivity
between the SEM host and the device to be added. Also, confirm whether the IP address of
the device to be added is valid and that the device is up and running properly.
8. After the operation succeeds and a success dialog box appears, click OK to close the dialog
box.
The newly-added devices are included in the list of devices.
NOTE: If you plan to upgrade a Gen2 system to a Gen3 single node system, you must remove
the device from the HP StoreOnce Enterprise Manager before the upgrade, and add it back to the
HP StoreOnce Enterprise Manager after the upgrade.
Working with orphan service sets
If there is replication between a Gen2 and Gen3 device, or between two Gen3 devices, and you
only add the Gen2 device by finding associated devices, then it is not possible to automatically
find the IP address of the Gen3 device. All the service set/device entries are entered into the
database. Click Device Management->Pending; this displays all the service sets/devices for which
the system cannot automatically find the IP address. Enter the IP address of the 26xx, 27xx, 42xx,
44xx, 45xx, 47xx, 49xx, B6200, or 6500 device corresponding to all the listed service set entries,
and then click OK.
Adding a device 15