HP I/O Module Installation Instructions
I/O Module
Installation Instructions
for HP high-density disk enclosures
Kit contents
• I/O module (2)
• Warranty documentation
• This document
Installation
The enclosure ships with two I/O modules, one for each storage
drawer. Installing additional I/O modules expands support from
single-domain to dual-domain.
CAUTION: If the I/O module is installed in an enclosure
for which it was not designed, the module will not function
properly. Read the labels on the I/O module and the
enclosure to confirm compatibility. For example, an I/O
module with a "6G IO module" label is supported for use
only in the 6G, D6000 disk enclosure; an I/O module with
no label is supported for use only in a 3G disk enclosure
such as the MDS600.
To install an I/O module:
1. Be sure the hard drive drawer is closed completely.
2. To remove the I/O blank, release the I/O blank handle, pull the
I/O blank handle down until it ejects the I/O blank, and then
remove the I/O blank from the enclosure.
3. To install the I/O module, insert the I/O module into the
enclosure and push the I/O module handle up. Be sure the I/O
module is seated fully, and the I/O module handle is in the
locked position.
The installation installation is complete.
To install the second I/O module in the other enclosure drawer, repeat
the procedure.
CAUTION: For best cooling practices, do not operate the
enclosure for extended periods with more than one
component or blank removed. When removing an active
component, replace it with a blank.
Regulatory compliance
identification numbers
For the purpose of regulatory compliance certifications and
identification, this product has been assigned a unique regulatory
model number. The regulatory model number can be found on the
product nameplate label, along with all required approval markings
and information. When requesting compliance information for this
product, always refer to this regulatory model number. The regulatory
model number is not the marketing name or model number of the
product.
European Union regulatory notice
Products bearing the CE marking comply with the following EU
Directives:
• Low Voltage Directive 2006/95/EC
• EMC Directive 2004/108/EC
• Ecodesign Directive 2009/125/EC, where applicable
CE compliance of this product is valid if powered with the correct
CE-marked AC adapter provided by HP.
Compliance with these directives implies conformity to applicable
harmonized European standards (European Norms) that are listed in
the EU Declaration of Conformity issued by HP for this product or
product family and available (in English only) either within the product
documentation or at the following HP website
(http://www.hp.eu/certificates) (type the product number in the
search field).
© Copyright 2012 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The only
warranties for HP products and services are set forth in the express warranty
statements accompanying such products and services. Nothing herein should
be construed as constituting an additional warranty. HP shall not be liable for
technical or editorial errors or omissions contained herein.
Bluetooth is a trademark owned by its proprietor and used by Hewlett-
Packard
Company under license.
Part Number: 536582-002
September 2012
Edition: 2
*536582-002*
536582-002