HP DDS/DAT tape drives UNIX, Linux and OpenVMS configuration guide (DW049-90930, May 2010)

Figure 2 SAM text-based interface

1. Enter sam at the command line.

% sam

2. Select the following:

Kernel Configuration > Kernel Configuration (character mode) > Modules

3. Highlight the stape driver. If the driver has not been added to the kernel, both Current State and

Planned State will read “unused”.

4. Type “m to modify the stape driver and “s” to set it to “static”. The Planned State will now

read “static”.

5. The stape driver is now added to the kernel.

6. If you are going to attach a media changer, use a similar procedure to change eschgr or schgr

to “static”.

7. Reboot the system.

For HP-UX 11iv3 (11.31)

1. Start up the SMH web-based interface.

% smh –w

This will attempt to launch a web browser. Mozilla browser

is the default when HP-UX 11i v3

is installed.

If Mozilla is being invoked for the first time you may be asked to agree to license terms for the software.

HP (HP-UX) servers and workstations10