Brocade Web Tools Administrator's Guide v6.2.0 (53-1001194-01, April 2009)

164 Web Tools Administrator’s Guide
53-1001194-01
FC-FC routing management
11
1. Select a switch from the Fabric Tree.
The selected switch appears in the Switch View.
2. Click FCR in the Manage section of the Tasks menu.
The FC Routing module displays (as shown in Figure 79). If FC-FC Routing is disabled, a
message to that effect displays on all the tabs in the module.
FIGURE 79 FC Routing module in Disabled mode with General tab selected
Viewing and managing LSAN fabrics
The LSAN Fabric tab (see Figure 80 on page 165) displays all the LSAN fabrics visible to your
switch, in both a tabular and tree form. (If FC-FC Routing is disabled, the table and tree nodes in
this tab are empty and the tree displays only the backbone switch.)
For more detailed information about a specific LSAN fabric, click a fabric name in the table and
then click View Details in the task bar. You can also click the fabric name in the tree on the left side
of the window.
When there is more than one router present in the backbone fabric with different backbone Fabric
IDs, the routers with the conflicting IDs are shown in a separate table on the LSAN Fabric tab.
To manage an LSAN fabric, select the fabric to manage and click Manage LSAN Fabric in the task
bar. A browser window is launched with the following url:
http://ip-address-of-lsan-fabric-switch