Brocade Web Tools Administrator's Guide v6.2.0 (53-1001194-01, April 2009)

Web Tools Administrator’s Guide 165

53-1001194-01

Viewing EX_Ports

For Brocade switches, this launches Web Tools. For non-Brocade fabrics, this launches the

element manager for that switch.

FIGURE 80 FC Routing module with LSAN Fabrics tab selected

Viewing EX_Ports

The EX_Ports tab (see Figure 81 on page 166) displays all of the EX_Ports on the switch, including

configuration and status information. The ports are sorted by slot number, and then by row number

within each slot. IP address information is displayed in IPv4 and IPv6 formats.

NOTE

If FC Routing is disabled, then you must disable all of the EX_Ports and you cannot enable them until

FC Routing is enabled.

For more detailed information about a specific port, click a port name in the table, and then click

View Details in the task bar. You can also click the port name in the tree on the left side of the

window.

From the EX_Ports tab, you can perform the following port management tasks by selecting a port in

the table, and then clicking a task in the task bar:

• Configure EX_Ports

• Edit an EX_Ports configuration

• Rename an EX_Port

• Swap the Port Index of an EX_Port (described in “Port swapping index” on page 92)