Brocade Web Tools Administrator's Guide v6.2.0 (53-1001194-01, April 2009)

Web Tools Administrator’s Guide 197
53-1001194-01
Setting up iSCSI Target Gateway Services
15
Configuring the IP interface
This step configures iSCSI ports (GbE Ports) found on the FC4-16IP. You must have at least one
iSCSI port configured to log into the iSCSI target.
There are two steps in this process:
• Configure the IP interface for iSCSI port.
• Configure the IP route for the iSCSI port.
The iSCSI Port Group tab allows you to configure iSCSI ports, display session details on a port, and
show the port statistics. It also allows you to view and configure the IP interface and routes that are
located on the IP Interface tab. You can edit or delete the IP address, but you cannot add any
additional IP addresses to this interface.
When you select the switch in the left pane, the right pane lists the tasks you can perform on that
switch in relation to one of the GbE ports.
When you select one of the GbE ports, you can perform the same tasks listed previously: view and
capture statistics related to the port, add or delete IP addresses, add or delete IP routes, view
current sessions, and view the iSCSI statistics in brief.
FIGURE 94 iSCSI Port tab
If an IP address or IP route is already configured on the GbE port, then it will not be editable as any
edits will disrupt any iSCSI traffic.
Configuring the IP route is optional because when an IP address is set up, a route is automatically
set up as well.