Brocade Web Tools Administrator's Guide v6.2.0 (53-1001194-01, April 2009)

198 Web Tools Administrator’s Guide
53-1001194-01
Setting up iSCSI Target Gateway Services
15
1. Open iSCSI Target Gateway Admin as described on page 194.
2. Select the iSCSI Port tab.
3. In the left pane, select the GbE port to use.
4. Select the IP Interface subtab and click Add.
5. Enter the IP address and subnet mask.
6. Enter the MTU size or accept the default MTU size, and click Add.
Editing an IP Address
1. Launch the iSCSI Target Gateway Admin module as described on page 194.
2. Select the iSCSI Port tab.
3. From the left pane, select the GbE port to use.
4. Select the IP Interface subtab and select the item on the tab.
5. Click Edit.
6. Click OK when you receive the Warning dialog box.
FIGURE 95 Edit IP Interface dialog box
7. Enter the subnet mask.
8. Enter the MTU size or accept the default MTU size, and click OK.
NOTE
To change the IP address, delete the current IP address and re-create it. You will not be
allowed to create an additional IP address for this interface, as there can be only one IP
address per interface.