Brocade Web Tools Administrator's Guide v6.2.0 (53-1001194-01, April 2009)

250 Web Tools Administrator’s Guide
53-1001194-01
IPSec over management ports
17
Enabling IPSec
Ethernet IPSec policies can be configured only after enabling IPSec by clicking the Enable button
below the Ethernet IPSec policies table (refer to Figure 123).
Establishing an IKE policy
When you establish an IKE policy, you identify a set of algorithms and authentication rules and
parameters to use in a key exchange.
1. Select the IKE tab on the IPSec Policies window for Ethernet IPSec.
The Add IKE Policy dialog box is displayed (Figure 124).
FIGURE 124 Add IKE Policy for management port
2. Type an IKE Policy Name.
3. Type the IP address of the authentication partner in Peer IP Address.
4. Type the switch’s local identifier in the Local Identifier field. This is normally the IP address in
IPv4 or IPv6 format, but it may also be a DNS name.