Brocade Web Tools Administrator's Guide v6.2.0 (53-1001194-01, April 2009)

Web Tools Administrator’s Guide 267
53-1001194-01
Displaying code page information
18
Configuring FMS mode parameters
1. Click a FICON-enabled switch from the Fabric Tree.
2. Open the Switch Administration window as described on page 41.
3. Click the FICON CUP tab.
The FICON CUP page displays the FICON Management Server page (see Figure 134 on
page 265). All attributes on this page are read-only until FMS mode is enabled.
4. To enable or disable an FMS mode parameter, click the check box next to the parameter. A
marked check box indicates that the parameter is enabled. You cannot configure the User
Alert Mode parameter in Web Tools, as it is read-only.
Displaying code page information
The Code Page section identifies the language used to exchange information between the FICON
director and Host Programming. It is a read-only field in Web Tools, as it is set by Host Programming
only. When FMS mode is disabled, the code page is displayed as unavailable.
1. Click a FICON-enabled switch from the Fabric Tree.
2. Open the Switch Administration window as described on page 41.
3. Click the FICON CUP tab.
The FICON CUP page displays the FICON Management Server page in front (see Figure 134 on
page 265). All attributes on this tab are read-only until FMS mode is enabled.
The code page format is displayed in the Code Page section as shown in the example below:
Language used to exchange information with Host Programming: (EBCDIC) USA/
Canada -- 00037
Director Clock
Alert Mode
Controls behavior for attempts to set the switch timestamp clock through the director console.
When it is enabled, the director console (Web Tools, in this case) displays warning indications
when the switch timestamp is changed by a user application. When it is disabled, you can
activate a function to automatically set the timestamp clock. There is no indication for
timestamp clock setting.
This parameter is set as disabled by the hardware after system installation, and can be reset
by Web Tools.
Host Control
Prohibited
Determines whether host programming allows modifying port connectivity.
Enabling this mode prohibits host programming control of port connectivity; otherwise, host
programming can manage port connectivity.
This parameter is set as disabled by the hardware after system installation. and can be reset
by Web Tools.
TABLE 22 FMS mode parameter descriptions (Continued)
Parameter Description