Brocade Web Tools Administrator's Guide v6.2.0 (53-1001194-01, April 2009)
48 Web Tools Administrator’s Guide
53-1001194-01
System configuration parameters
3
System configuration parameters
You must disable the switch before you can configure fabric parameters.
You can change the following system configuration parameters:
• Switch fabric settings
• Virtual channel settings
• Arbitrated loop parameters
• System services
• Signed firmware
Configuring fabric settings
1. Open the Switch Administration window as described on page 41.
2. Disable the switch as described in “Enabling and disabling a switch” on page 46.
3. Click the Configure tab.
4. Click the Fabric subtab.
FIGURE 23 Configure tab, Fabric subtab
5. Make the fabric parameter configuration changes.
6. Click Apply.
7. E n a b le t h e sw i tc h as described in “Enabling and disabling a switch” on page 46.