Brocade Web Tools Administrator's Guide v6.2.0 (53-1001194-01, April 2009)

Web Tools Administrator’s Guide 51
53-1001194-01
Licensed feature management
3
Configuring system services
You can enable or disable FCP read link status (RLS) probing for F_Ports and FL_Ports. It is
disabled by default.
1. Open the Switch Administration window as described on page 41.
2. Disable the switch as described in “Enabling and disabling a switch” on page 46.
3. Click the Configure tab and click the System subtab.
4. Select the Disable RLS Probing check box to disable RLS probing. Clear the check box to
enable RLS probing.
5. Click Apply.
6. Enable the switch as described in “Enabling and disabling a switch” on page 46.
Configuring signed firmware
When the firmware is downloaded to a device, the system can validate the firmware based on a
configuration setting. By default, the signed firmware download is not validated.
NOTE
During the first download, the system ignores the signed firmware. After the first download, the
public key is downloaded and then, in subsequent downloads, you can turn on the feature.
You can view the public key on the Firmware Download tab in the Switch Administration window.
1. Open the Switch Administration window as described on page 41.
2. Click the Configure tab and click the Firmware subtab.
3. Select the Enable Signed Firmware Download check box.
4. Click Apply.
Licensed feature management
The licensed features currently installed on the switch are listed in the License tab of the Switch
Administration window, as shown in Figure 24. If the feature is listed, such as the EGM license, it is
installed and immediately available. When you enable some licenses, such as ISL Trunking, you
might need to change the state of the port to enable the feature on the link. For time-based
licenses, the expiry date is included. Scroll to the right to check the expiry date for a time-based
license.