Brocade Fabric OS Command Reference Manual - Supporting Fabric OS v5.3.0 (53-1000436-01, June 2007)

Fabric OS Command Reference Manual 705
53-1000436-01
trunkDebug
2
trunkDebug
Debugs a trunk link failure.
Synopsis trunkdebug port1 port2
Description Use this command to debug a trunk link failure. This command reports one of the following
messages, based on the trunking properties of the two specified ports:
Switch does not support trunking
Trunking license required
Trunking not supported in switch interop mode
port port_id is not E_Port
port port_id trunking disabled
port port_id speed is not 2G or 4G
port port_id and port port_id are not in same port group
port port_id and port port_id connect to different switches
port port_id and port port_id connect to the switch WWN
port port_id is not a trunking port due to: E_Port being disabled, or trunking might be disabled at
remote port
port port_id and port port_id cannot trunk, please check link length to make sure difference is less
than 400 m
The execution of this command is subject to Admin Domain restrictions that may be in place.
Operands This command has the following operands:
port1 Specify the area number of port 1. Use the switchShow command to view the
area numbers for a port. This operand is required.
port2 Specify the area number of port 2. Use the switchShow command to view the
area numbers for a port. This operand is required.
Examples To debug a trunk connection:
switch:admin> trunkdebug 43 44
Switch does not support trunking
switch:admin> trunkdebug 62 63
port 62 and 63 are trunked together
See Also portCfgTrunkPort, switchCfgTrunk, trunkShow