Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 5-1

Publication Number: 53-1000242-01

Chapter

BM System Messages

BM-1001

Message

Probable

Cause

Indicates that the software running on the CP cannot communicate with the AP blade in the indicated

slot, in order to determine AP blade's firmware version. This can be due to one of the following:

• The CP blade is running a much newer version than the AP blade

• The CP blade is running a much older version than the AP blade

Recommended

Action

The problem can be corrected by changing the version of firmware on the CP or AP blades. The

firmware version on the CP blade can be changed using the firmwareDownload command. Refer to the

release notes to determine whether a non-disruptive firmwareDownload is supported between the

versions. As the AP and CP blades cannot communicate, it is not possible to load new firmware on the

AP blade. If required, send the AP blade back to the factory to get a new firmware version installed.

Severity ERROR

BM-1002

Message

Probable

Cause

The CP has established a connection to the BP and can communicate.

Recommended

Action

No action is required.

Severity INFO

<timestamp>, [BM-1001], <sequence-number>,, ERROR, <system-name>,

BM protocol version <Protocol version> in slot <Slot number>

<timestamp>, [BM-1002], <sequence-number>,, INFO, <system-name>,

Connection established between CP and blade in slot <Slot number>