Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 9-7
Publication Number: 53-1000242-01
EM-1017
9
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WAR NIN G
EM-1017
Message
Probable
Cause
Indicates that a user did not commit a changed WWN value prior executing a reboot, power cycle, or
firmwareDownload operation.
Recommended
Action
Change and commit the new WWN value.
Severity WAR NIN G
EM-1018
Message
Probable
Cause
Indicates that there was a failure to read the chassis type from the system.
Recommended
Action
Verify that the CP blade is operational and is properly seated in its slot.
Severity CRITICAL
EM-1019
Message
Probable
Cause
Indicates that the current chassisConfig option is not supported by the firmware on the standby CP. This
is true even if the standby comes up and appears to be operational. HA synchronization of the CPs will
not be allowed.
<timestamp>, [EM-1017], <sequence-number>,, WARNING, <system-name>,
Uncommitted WWN change detected. Cold reboot required.
<timestamp>, [EM-1018], <sequence-number>, FFDC, CRITICAL, <system-
name>, CP blade in slot <slot number> failed to retrieve current
chassis type (<detailed fault descriptor>/<PLACE HOLDER>/0x<PLACE
HOLDER>).
<timestamp>, [EM-1019], <sequence-number>,, WARNING, <system-name>,
Current chassis configuration option (<Chassis config option
currently in effect>) is not compatible with standby firmware
version (Pre 4.4), cannot allow HA Sync.