Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 11-7
Publication Number: 53-1000242-01
FABR-1016
11
FABR-1016
Message
Probable
Cause
Indicates that FICON mode is enabled on the switch through a user interface command.
Recommended
Action
No action is required.
Severity WAR NIN G
FABR-1017
Message
Probable
Cause
Indicates that FICON mode is disabled on the switch through a user interface command.
Recommended
Action
No action is required.
Severity WAR NIN G
FABR-1018
Message
Probable
Cause
Indicates that a failure occurred when trying to set the principal switch using the fabricPrincipal
command. The message notifies the user that the switch failed to become the principal switch because
either:
• The switch joined an existing fabric and bypassed the F0 state.
• The fabric already contains a principal switch that has a lower WWN.
Recommended
Action
Make sure that no other switches is configured as the principal switch. Force a fabric rebuild by using
the switchDisable and switchEnable commands.
Refer to the Fabric OS Command Reference for more information the fabricPrincipal command.
<timestamp>, [FABR-1016], <sequence-number>,, WARNING, <system-
name>, ficonMode is enabled.
<timestamp>, [FABR-1017], <sequence-number>,, WARNING, <system-
name>, ficonMode is disabled.
<timestamp>, [FABR-1018], <sequence-number>,, WARNING, <system-
name>, PSS principal failed (<reason for not becoming the principal
switch>: <WWN of new principal switch>)