Manualshelf

Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

ManualsBrandsHP ManualsComputer AccessoriesHP DC SAN Director Switch 16-port 8Gb Fibre Channel Blade Option
221222223224225226227228229230
Fabric OS Message Reference 25-23
Publication Number: 53-1000242-01
FW-1160
25
FW-1160
Message
Probable
Cause
Indicates that the number of link failures that the port experiences has changed. Link loss errors occur
when a link experiences a loss of signal and fails. Both physical and hardware problems can cause link
loss errors. Link loss errors frequently occur due to a loss of synchronization. Check for concurrent loss
of synchronization errors and, if applicable, troubleshoot them.
Recommended
Action
Check both ends of your cable connection. Verify that the cable and SFPs are not faulty.
Losses of synchronization commonly causes link failures. If you receive concurrent loss of
synchronization errors, troubleshoot the loss of synchronization.
Severity INFO
FW-1161
Message
Probable
Cause
Indicates that the number of link failures that the port experiences has fallen below the low boundary.
Link loss errors occur when a link experiences a loss of signal and fails. Both physical and hardware
problems can cause link loss errors. Link loss errors frequently occur due to a loss of synchronization.
Check for concurrent loss of synchronization errors and, if applicable, troubleshoot them. A low
number of link loss errors means that the switch is functioning normally.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the end-user
installation.
Severity INFO
FW-1162
Message
<timestamp>, [FW-1160], <sequence-number>,, INFO, <system-name>,
<Port Name>, <Label>, value has changed(High=<High value>, Low=<Low
value>). Current value is <Value> <Unit>.
<timestamp>, [FW-1161], <sequence-number>,, INFO, <system-name>,
<Port Name>, <Label>, is below low boundary(High=<High value>,
Low=<Low value>). Current value is <Value> <Unit>.
<timestamp>, [FW-1162], <sequence-number>,, WARNING, <system-name>,
<Port Name>, <Label>, is above high boundary(High=<High value>,
Low=<Low value>). Current value is <Value> <Unit>.