Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 25-81
Publication Number: 53-1000242-01
FW-1435
25
FW-1435
Message
Probable
Cause
Indicates that the switch status is not in a healthy state. This occurred because the flash usage is out of
range. The policy was set using the switchStatusPolicySet command.
Recommended
Action
Run the saveCore command to clear out the kernel flash. Refer to the Fabric OS Command Reference
for more information about this command.
Severity WAR NIN G
FW-1436
Message
Probable
Cause
Indicates that the switch status is not in a healthy state. This occurred because the number of marginal
ports is greater than or equal to the policy set using the switchStatusPolicySet command. A port is
faulty when the port value for Link Loss, Synchronization Loss, Signal Loss, Invalid word, Protocol
error, CRC error, Port state change or Buffer Limited Port is above the high boundary.
Recommended
Action
Replace any faulty or deteriorating SFPs.
Severity WAR NIN G
FW-1437
Message
Probable
Cause
Indicates that the switch status is not in a healthy state. This occurred because the number of faulty ports
is greater than or equal to the policy set by the switchStatusPolicySet command. A port is considered
faulty due to hardware failure such as a faulty SFP or port.
Recommended
Action
Replace any faulty or deteriorating SFPs.
<timestamp>, [FW-1435], <sequence-number>,, WARNING, <system-name>,
Switch status change contributing factor Flash: usage out of range.
<timestamp>, [FW-1436], <sequence-number>,, WARNING, <system-name>,
Switch status change contributing factor Marginal ports: <Num of
marginal ports and the port numbers> marginal ports. (Port(s)
<Unknown>)
<timestamp>, [FW-1437], <sequence-number>,, WARNING, <system-name>,
Switch status change contributing factor Faulty ports: <Num of
faulty ports> faulty ports.