Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 41-1
Publication Number: 53-1000242-01
Chapter
41
MFIC System Messages
MFIC-1001
Message
Probable
Cause
Indicates that the system is temporarily out of resources.
Recommended
Action
No action is required; this message is often transitory.
If the message persists, run a switch reboot or an haFailover (if applicable).
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
MFIC-1002
Message
Probable
Cause
Indicates that custom switch node descriptor (NID) fields have not been programmed in nonvolatile
storage. The default values are used. The Switch NID is used only in the following SB ELS frames:
Request Node Identification Data (RNID) and Registered Link Incident Record (RLIR).
The use of SB-3 link incident registration and reporting is typically limited to FICON environments.
Recommended
Action
No action is required if SB-3 link incident registration and reporting is not used by the host or if default
values are desired for the switch node descriptor fields.
Severity INFO
<timestamp>, [MFIC-1001], <sequence-number>,, ERROR, <system-name>,
failure at sysmod_scn registry rc= <failure reason>
<timestamp>, [MFIC-1002], <sequence-number>,, INFO, <system-name>,
Chassis FRU header not programmed for switch NID, using defaults
(applies only to FICON environments).