Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

58-20 Fabric OS Message Reference
Publication Number: 53-1000242-01
SEC-1080
58
SEC-1080
Message
Probable
Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity ERROR
SEC-1081
Message
Probable
Cause
Indicates that the DCC policy name given in the secPolicyCreate command was the same as another
DCC policy.
Recommended
Action
Make sure that the DCC policy name has a unique alpha-numeric string, and run the secPolicyCreate
command again.
Severity ERROR
SEC-1082
Message
Probable
Cause
Indicates that the security policy was not created due to faulty input or low resources.
Recommended
Action
Use proper syntax when creating policies. If the security database is too large, you must delete other
members within the database before adding new members to a policy.
Severity ERROR
<timestamp>, [SEC-1080], <sequence-number>,, ERROR, <system-name>,
Operation denied. Please, use secModeEnable command.
<timestamp>, [SEC-1081], <sequence-number>,, ERROR, <system-name>,
Entered a name for a DCC policy ID that was not unique.
<timestamp>, [SEC-1082], <sequence-number>,, ERROR, <system-name>,
Failed to create <policy name> policy.