Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 58-21
Publication Number: 53-1000242-01
SEC-1083
58
SEC-1083
Message
Probable
Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity ERROR
SEC-1084
Message
Probable
Cause
Indicates that the specified policy already exists.
Recommended
Action
No action is required.
Severity ERROR
SEC-1085
Message
Probable
Cause
Indicates that the security policy was not created.
Recommended
Action
Check that the current policy configuration is valid. For example, the RSNMP policy cannot exist
without the WSNMP policy.
Severity ERROR
<timestamp>, [SEC-1083], <sequence-number>,, ERROR, <system-name>,
Name already exists.
<timestamp>, [SEC-1084], <sequence-number>,, ERROR, <system-name>,
Name exists for different type <Policy name>.
<timestamp>, [SEC-1085], <sequence-number>,, ERROR, <system-name>,
Failed to create <policy name>.