Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 58-23
Publication Number: 53-1000242-01
SEC-1089
58
SEC-1089
Message
Probable
Cause
Indicates that the security policy name in the secPolicyAdd command does not exist.
Recommended
Action
Create the appropriate security policy first, then use its name in the secPolicyAdd command to add new
members.
Severity ERROR
SEC-1090
Message
Probable
Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
in the ready state. If a switch is in the error state, the database might not be correctly updated for that
specific switch.
Severity ERROR
SEC-1091
Message
Probable
Cause
Indicates that the specified policy member does not exist or the policy itself does not exist.
Recommended
Action
Verify that the security policy name or member ID is correct.
Severity ERROR
<timestamp>, [SEC-1089], <sequence-number>,, ERROR, <system-name>,
Policy name <policy name> was not found.
<timestamp>, [SEC-1090], <sequence-number>,, ERROR, <system-name>,
SCC list contains FCS member. Please remove member from the FCS
policy first.
<timestamp>, [SEC-1091], <sequence-number>,, ERROR, <system-name>,
No policy to remove.