Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 58-27
Publication Number: 53-1000242-01
SEC-1101
58
SEC-1101
Message
Probable
Cause
Indicates that the security enable failed on the fabric because one or more switches in the fabric are
busy.
Recommended
Action
Verify that the security event was planned. If the security event was planned, run the secFabricShow
command to verify that all switches in the fabric are in the ready state. When all switches are in the
ready state, retry the operation.
Severity ERROR
SEC-1102
Message
Probable
Cause
Indicates that the switch failed to download certificate, security database, or policies. This can happen
when switch does not get enough resources to complete the operation, fabric has not stabilized, or
policy database is an invalid format.
Recommended
Action
Wait for fabric to become stable and then retry the operation. If the policy database is in an illegal
format (with configDownload), correct the format and retry the operation.
Severity ERROR
SEC-1104
Message
Probable
Cause
Indicates that the switch failed to get either the primary certificate or a primary public key.
Recommended
Action
Verify that the primary switch has a valid certificate installed and retry the operation. If a valid
certificate is not installed, install a certificate by following the procedure specified in the Secure Fabric
OS Administrator's Guide.
Severity ERROR
<timestamp>, [SEC-1101], <sequence-number>,, ERROR, <system-name>,
Failed to enable security on all switches. Please retry later.
<timestamp>, [SEC-1102], <sequence-number>,, ERROR, <system-name>,
Fail to download <security data>.
<timestamp>, [SEC-1104], <sequence-number>,, ERROR, <system-name>,
Fail to get primary <Certificate or public key>.