Manualshelf

Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

ManualsBrandsHP ManualsComputer AccessoriesHP DC SAN Director Switch 16-port 8Gb Fibre Channel Blade Option
421422423424425426427428429430
Fabric OS Message Reference 58-35
Publication Number: 53-1000242-01
SEC-1138
58
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
in the ready state. If a switch is in the error state, the database might not be correctly updated for that
switch. This message might also be the result of an internal corruption or a hacker attack to the secure
fabric.
Severity ERROR
SEC-1138
Message
Probable
Cause
Indicates that a non-primary FCS switch received a security database download.
Recommended
Action
Verify that the security event was planned. If the security event was planned, no action is required. If the
security event was not planned, take appropriate action as defined by your enterprise security policy.
Severity INFO
SEC-1139
Message
Probable
Cause
Indicates that the receiving switch fails to validate the security database sending from the primary FCS
switch. This message usually indicates that the data package is corrupted, the time stamp on the package
is out of range as a result of a replay attack or out-of-sync time service, or the signature verification
failed. Signature verification failure indicates either an internal error (such as losing the primary public
key) or an invalid database.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be
in the ready state. If a switch is in the error state, the database might not be correctly updated for that
switch. This message might also be the result of an internal corruption or a hacker attack to the secure
fabric.
Severity ERROR
SEC-1142
Message
<timestamp>, [SEC-1138], <sequence-number>,, INFO, <system-name>,
Security database download received from Primary FCS.
<timestamp>, [SEC-1139], <sequence-number>,, ERROR, <system-name>,
THe RSNMP_POLICY cannot exist without the WSNMP_POLICY.
<timestamp>, [SEC-1142], <sequence-number>,, INFO, <system-name>,
Reject new policies. <reason text>.