Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 58-37
Publication Number: 53-1000242-01
SEC-1153
58
SEC-1153
Message
Probable
Cause
Indicates that RCS is not supported.
Recommended
Action
Run the rcsInfoShow command to view RCS capability on the fabric. RCS must be capable on all
switches in the fabric to be enabled. If all switches are capable, it is automatically enabled.
For any switch that does not support RCS, obtain the latest firmware version from your switch supplier,
and run the firmwareDownload command to upgrade the firmware.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity INFO
SEC-1154
Message
Probable
Cause
Indicates that either the defined or the active policy could not be updated. If the policy database is very
large, it might not be able to change the index/area because the new policy database exceeds the
maximum size. This message can also be caused when the switch is short of memory. The status values
can be either defined, active, or both. A negative value means that a policy set was failed by the
daemon.
Recommended
Action
Reduce the size of the policy database.
Severity INFO
SEC-1155
Message
Probable
Cause
Indicates that either the defined or active policy was too large after modifying the index/area ID. The
status values can be either defined, active, or both. A negative value means that a policy set was failed
by the daemon.
<timestamp>, [SEC-1153], <sequence-number>,, INFO, <system-name>,
Error in RCA: RCS is not supported
<timestamp>, [SEC-1154], <sequence-number>,, INFO, <system-name>,
PID change failed: <Reason> <defined status> <active status>.
<timestamp>, [SEC-1155], <sequence-number>,, INFO, <system-name>,
PID change failed: <Reason> <defined status> <active status>.