Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

63-2 Fabric OS Message Reference
Publication Number: 53-1000242-01
SYSC-1003
63
SYSC-1003
Message
Probable
Cause
Indicates that on system startup, the option configuration file corresponding to the chassisConfig option
read could not be found. This indicates that option is not supported on this platform running this version
of the firmware.
It could also indicate that the current option number could not be read from the chassis option storage
device (the WWN card).
This message occurs only on the SilkWorm 24000 and 48000.
Recommended
Action
Run the chassisConfig command to change to one that is valid on this platform running this firmware.
Note that the chassisConfig option 1 should be valid for all platforms running any valid firmware.
Severity CRITICAL
SYSC-1004
Message
Probable
Cause
Indicates that a terminated daemon is restarted by system automatically.
Recommended
Action
Use the supportSave command to gather troubleshoot data. No further action is required.
Severity INFO
SYSC-1005
Message
Probable
Cause
Indicates that a terminated daemon is not restarted, either due to restart limit is reached or restart action
fails
<timestamp>, [SYSC-1003], <sequence-number>, FFDC, CRITICAL,
<system-name>, Chassis config option <Option number read from the
chassis option storage device> is not supported by CP Blade with ID
<Blade ID (platform) number from the Active CP>. Change the chassis
configuration <Steps to change chassis configuration>
<timestamp>, [SYSC-1004], <sequence-number>,, INFO, <system-name>,
Daemon <Daemon name to restart> restart successful
<timestamp>, [SYSC-1005], <sequence-number>,, WARNING, <system-
name>, Daemon <Daemon name to restart> is not restarted (Reason:
<Restart failure reason>)