Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

79-2 Fabric OS Message Reference
Publication Number: 53-1000242-01
SULB-1003
79
SULB-1003
Message
Probable
Cause
Indicates that the firmwareCommit command has been entered.
Recommended
Action
No action is required. Run the firmwareDownloadStatus command for more information.
Severity INFO
SULB-1009
Message
Probable
Cause
Indicates that the firmwareDownload command failed. The additional status code and error code
provide debugging information.
Table 79-1 lists firmwareDownload status messages and status codes. Some of them will not show up
in this RASLOG message. They are listed for the sake of completeness.
Table 79-1 Status Messages and Status Codes
AUDIT, <timestamp>, [SULB-1003], INFO, FIRMWARE, <event-initiator-
details>, <event-location>, , Firmwarecommit has started.
AUDIT, <timestamp>, [SULB-1009], INFO, FIRMWARE, <event-initiator-
details>, <event-location>, , Firmwaredownload command failed.
status: 0x<status code>, error: 0x<error code>.
Status Message Status Code
"firmwareDownload sanity check failed." 0x30
"Sanity check failed because system is non-redundant." 0x31
"Sanity check failed because firmwareDownload is already in progress." 0x32
"Sanity check failed because FABRIC OS is disabled on Active CP." 0x33
"Sanity check failed because HAMD is disabled on Active CP." 0x34
"Sanity check failed because firmwareDownload is already in progress." 0x35
"Sanity check failed because FABRIC OS is disabled on Standby CP." 0x36
"Sanity check failed because HAMD is disabled on Standby CP." 0x37
"firmwareDownload failed on Standby CP." 0x40
"firmwareDownload failed on Standby CP." 0x41
"firmwareDownload failed on Standby CP." 0x42
"firmwareCommit failed on Standby CP." 0x43
"firmwareDownload failed." 0x44