Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 79-11
Publication Number: 53-1000242-01
SULB-1021
79
SULB-1021
Message
Probable
Cause
Indicates that the firmware is being loaded to the indicated blade.
Recommended
Action
Run the firmwareDownloadStatus command to monitor the firmwareDownload progress. After it
finishes, run the firmwareShow command to verify the firmware versions.
Severity WAR NIN G
SULB-1023
Message
Probable
Cause
The error can be caused by an unexpected disruption of the firmwareDownload command, for
example, powering off and on of the indicated BP blade in the middle of a firmwareDownload. This
error can also be caused by persistent storage hardware failure, or a software error.
Recommended
Action
firmwareCommit will be started automatically after the blade boots up. If at the end of
firmwareCommit, the blade firmware version is still inconsistent with the active CP firmware,
firmwaredownload will be started automatically to the blade again. Continue to run the
firmwareDownloadStatus command to monitor the progress. However, if this problem persists,
contact the service provider for further actions.
Severity WAR NIN G
SULB-1024
Message
Probable
Cause
Indicates that the firmwareCommit operation has completed on the indicated blade.
AUDIT, <timestamp>, [SULB-1021], WARNING, FIRMWARE, <event-
initiator-details>, <event-location>, , Firmware is being
downloaded to the blade in slot <Slot number>.
AUDIT, <timestamp>, [SULB-1023], WARNING, FIRMWARE, <event-
initiator-details>, <event-location>, , The blade in slot <Slot
number> has rebooted during firmwaredownload.
AUDIT, <timestamp>, [SULB-1024], WARNING, FIRMWARE, <event-
initiator-details>, <event-location>, , Firmware commit has
completed on the blade in slot <Slot number>.