Brocade Fabric OS Message Reference Guide (53-1000242-01, November 2006)

Fabric OS Message Reference 2-11
Publication Number: 53-1000242-01
AUTH-1033
2
AUTH-1033
Message
Probable
Cause
Indicates that an entity was not configured in the SCC policy and tried to connect to the port.
Recommended
Action
Add the entity's WWN to the SCC policy and reinitialize authentication by using the portDisable and
portEnable commands or the switchDisable and switchEnable commands.
Severity ERROR
AUTH-1034
Message
Probable
Cause
Indicates that the specified entity name in the payload is not in the correct format.
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
AUTH-1035
Message
Probable
Cause
Indicates that a particular data field in the authentication message has an invalid length field. This error
usually relates to internal failure.
Recommended
Action
Usually this problem is transient. The authentication might fail.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
<timestamp>, [AUTH-1033], <sequence-number>,, ERROR, <system-name>,
Disable port <port number> due to unauthorized switch <switch WWN
value>
<timestamp>, [AUTH-1034], <sequence-number>,, ERROR, <system-name>,
Failed to validate name <entity name> in <authentication message>:
port <port number>
<timestamp>, [AUTH-1035], <sequence-number>,, ERROR, <system-name>,
Invalid <data type> length in <message phase> message: length <data
length>, port <port number>