Fabric Watch Administrator's Guide v7.0.0 (53-1002153-01, April 2011)

54 Fabric Watch Administrator’s Guide
53-1002153-01
Recommended settings for Fabric, SFP, Performance, Security classes
6
Displaying the number of 16 Gbps SFP operational hours
To show the number of hours that the 16 Gbps SFP is operational, enter the thConfig command
using the following parameter. Note that the only supported timebase for this area is none.
switch:admin> thconfig --show sfp -area PWRONHRS -sfptype 16GSWL
Displaying the SFP health information
The sfpshow command displays the health of 10 and 16 Gbps SFPs and the QSFP.
Enter the sfpshow command using the following parameter:
switch:admin> sfpshow --health
Fabric Watch monitors the SFP’s current, voltage, receiver (RXP), and transmitter (TXP) and if any of
these parameters crosses the low or high thresholds, the state of the SFP is yellow; otherwise, the
state is green. The SFP can also be in one of the following states:
• Paused—health monitoring is not enabled.
• No license—the switch does not have the Fabric Watch license.
• Unknown—Fabric Watch cannot determine the state of the SFP.
Recommended settings for Fabric, SFP, Performance,
Security classes
Table 14 lists the recommended settings for the Fabric, SFP, Security, and Performance classes
discussed in this chapter. For all of these classes, it is recommended that you use the default
settings.
TABLE 14 Recommended settings for Fabric, SFP, Performance, and Security classes
E=Error_Log, S=SNMP_Trap,
P=Port_LOG_LOCK,
M=EMAIL_ALERT, F=Port Fence
Trait Configuration
Class
Area
Default
Custom
Unit
Time Base
Low Thresh
High Thresh
Buffer
Default
Custom
Below Above
Notes
Fabric E_Port downs X Downs None 0 0 0 X
Fabric reconfig X Reconfigs None 0 0 0 X
Domain ID
changes
X DID changes None 0 0 0 X
Segmentation X Segmentations None 0 0 0 X
Zone changes X Zone changes None 0 0 0 X
Fabric logins X Logins None 0 0 0 X