Access Gateway Administrator's Guide (53-1001760-01, June 2010)

Access Gateway Administrator’s Guide 7

53-1001760-01

Chapter

Configuring Ports in Access Gateway mode

In this chapter

•Enabling and disabling Access Gateway mode . . . . . . . . . . . . . . . . . . . . . . . . 7

•Access Gateway mapping . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10

•N_Port configurations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24

Enabling and disabling Access Gateway mode

Use the following steps to enable and disable Access Gateway mode. After you enable AG mode,

some fabric information is erased, such as the zone and security databases. Enabling AG mode is

disruptive because the switch is disabled and rebooted. For more information on the ag commands

used in these steps, refer to the Fabric OS Command Reference.

1. Before enabling or disabling a switch to AG mode, save the current configuration file using the

configupload command in case you might need this configuration again.

2. Ensure that no zoning or Admin Domain (AD) transaction buffers are active. If any transaction

buffer is active, enabling AG mode will fail with the error, “Failed to clear Zoning/Admin Domain

configuration”.

3. Verify that the switch is set to Native mode or interopmode 0.

a. Issue the switchshow command to verify the switch mode.

b. If the switch mode is anything other than 0, issue the interopmode 0 command to set the

switch to Native mode.

For more information on setting switches to Native mode, refer to the Fabric OS Administrator’s

Guide.

4. Enter the switchdisable command.

switch:admin> switchdisable

This command to disables all user ports on a switch. All Fibre Channel ports are taken offline.

If the switch was part of a fabric, the remaining switches reconfigure. You must disable the

switch before making configuration changes.

5. Enter the ag

--modeenable command.

switch:admin> ag --modeenable

The switch automatically reboots and comes back online in AG mode using a factory default

port mapping. For more information on AG default port mapping, see Table 5 on page 12.

6. Enter the ag

--modeshow command to verify that AG mode is enabled.

switch:admin> ag --modeshow

Access Gateway mode is enabled.