Access Gateway Administrator's Guide (53-1001760-01, June 2010)

Access Gateway Administrator’s Guide 15
53-1001760-01
Access Gateway mapping
2
Removing F_Ports from N_Ports
1. Connect to the switch and log in using an account assigned to the admin role.
2. Remove any preferred secondary N_Port settings for the F_Port. Refer to “Deleting F_Ports
from a preferred secondary N_Port” on page 46 for instructions.
3. Enter the ag
--mapdel N_Port command with the “[fprot;[fport]” option to remove the F_Port
from the N_Port.
The f_portlist can contain multiple F_Port numbers separated by semicolons, for example
“17;18”.
switch:admin> ag --mapdel 17;18
F-Port to N-Port mapping has been updated successfully
4. Enter the switchshow command to verify that the F_Port is free (unassigned).
Unassigned F_Port status is Disabled (No mapping for F_Port). See port 6 in the following
example.
switch:admin> switchshow
switchName: fsw534_4016
switchType: 45.0
switchState: Online
switchMode: Access Gateway Mode
switchWwn: 10:00:00:05:1e:02:1d:b0
switchBeacon: OFF
Area Port Media Speed State Proto
=====================================
0 0 cu AN No_Sync
1 1 cu AN No_Sync Disabled (N-Port Offline for F-Port)
2 2 cu AN No_Sync Disabled (N-Port Offline for F-Port)
3 3 cu AN No_Sync Disabled (N-Port Offline for F-Port)
4 4 cu AN No_Sync Disabled (N-Port Offline for F-Port)
5 5 cu AN No_Sync Disabled (N-Port Offline for F-Port)
6 6 cu AN No_Sync Disabled (No mapping for F-Port)
7 7 cu AN No_Sync
8 8 cu AN No_Sync
9 9 cu AN No_Sync
10 10 -- N4 No_Module
11 11 -- N4 No_Module
12 12 -- N4 No_Module
13 13 id N4 Online N-Port 10:00:00:05:1e:35:10:1e 0x5a0a00
14 14 id N4 Online N-Port 10:00:00:05:1e:35:10:1e 0x5a0900
15 15 id N4 Online N-Port 10:00:00:05:1e:35:10:1e 0x5a0800
Device-based mapping
This feature allows you to map individual N_Port ID virtualization (NPIV) devices to N_Ports. By
mapping device WWNs directly to an N_Port group (recommended) or specific N_Ports, traffic from
the device will always go to the same N_Port or N_Port group, regardless of the F_Port where the
device logs in. When Port Grouping Policy and WWN Load Balancing mode is enabled for a port
group, WWNs mapped to that port group are automatically balanced among the online N_Ports in
that group (refer to “Port Grouping policy modes” on page 36).