Brocade Fabric Manager Administrator's Guide v6.1.0 (53-10000610-02, June 2008)

176 Fabric Manager Administrator’s Guide
53-10000610-02
Domain ID configuration on a phantom switch
11
Configuring asset polling
1. Select the amount of time between polling that Fabric Manager should wait to check for state
changes within the fabric.
2. If no state changes have been received, set the amount of time that Fabric Manager should
wait before polling again.
FIGURE 115 Configure asset polling
3. Click OK.
To reset the settings to the default values based on your SAN size, click Reset.
Domain ID configuration on a phantom switch
Selecting a fabric from the metaSAN view shows the phantom switches available in the fabric,
listed as nodes. At least one switch in the fabric must be running Fabric OS v5.3.0 or later.
Configuring the domain ID on a phantom switch
1. In the metaSAN view, move to the Information panel and select the switch.
2. Right-click on the fabric containing the switch and select Configure Domain ID, as shown in
Figure 116.
• Switch status
change
• Port disabled • Effective Zone Cfg changed /
disabled
• Changed related to
Default Zone
Access mode
• Zone DB manipulations
TABLE 17 Asset collection triggers (Continued)