Brocade Fabric Manager Administrator's Guide v6.1.0 (53-10000610-02, June 2008)

Fabric Manager Administrator’s Guide 193
53-10000610-02
Work with iSCSI information
14
iSCSI summary
The iSCSI Summary tab, shown in Figure 124, displays a summary of iSCSI-specific parameters as
well as a table of information about iSCSI-capable switches.
The information shown is in the context of user selection. If you made no selection, the information
is SAN-wide; if you selected a fabric, the information is fabric-wide, and if you selected a switch, the
information is specific to that switch. Because virtual targets are fabric-wide entities, if you click
this tab in the switch context, the value for No. of iSCSI Targets is N/A.
Viewing additional iSCSI-specific details about a switch
Right-click a switch in the table and click iSCSI Configuration in the context menu.
The Web Tools iSCSI Target Gateway Admin module displays, from which you can view and
configure iSCSI parameters (see “Set up iSCSI Target Gateway services” on page 197 for more
information on configuring iSCSI parameters).
Configuring Discovery Domain and Discovery Domain Sets
Right-click a switch in the table and click Configure DD/DDSet in the context menu.
The Web Tools iSCSI Target Gateway Admin module displays, from which you can configure and
edit the DD and DDSet details (see “Set up iSCSI Target Gateway services” on page 197 for
more information on configuring DD and DDSet details).
iSCSI ports
The iSCSI Ports tab, shown in Figure 125, lists the iSCSI (GigE) ports in an iSCSI-capable SAN,
fabric, or switch. This tab shows only the GigE ports on FC4-16IP port blades. The portal IP is shown
as N/A for non-configured GigE ports. You can filter the list based on portal IP and switch IP
addresses.
FIGURE 125 iSCSI tab, iSCSI Ports view