Brocade Fabric OS Command Reference Manual Supporting Fabric OS v7.0.0 (April 2011)

Fabric OS Command Reference xxix
53-1002147-01
• supportShowCfgShow
• fosConfig
The following command options are deprecated:
• cfgDefault - -chassis
• portCmd -tperf -loop
• portCmd -tperf -crc
• thConfig - ST (State Change) area of the SFP class is no longer supported.
• fipsCfg --disable fips (Brocade internal use only)
• firmwareDownload -a, -e, and -o options are deprecated; to be removed in a later release.
CLI usage conventions
• Some Fabric OS show commands display certain switch- or fabric components in three-digit decimal
numbers, for example 003. When you use these numeric identifiers as inputs to other commands,
you must remove the leading zeros; otherwise the commands will either fail or generate incorrect
results. Adding zeros to any decimal number in a command input will cause that number to be
treated as an Octal number.
• Automatic page breaks in CLI command output displays are being phased out. Use the more option
to display command output with page breaks: command | more. Do not use the more option in
conjunction with help pages. Executing help command | more will display a command “no manual
entry for command” message.
Document conventions
This section describes text formatting conventions and important notices formats.
Text formatting
The narrative-text formatting conventions that are used in this document are as follows:
bold text Identifies command names
Identifies GUI elements
Identifies keywords and operands
Identifies text to enter at the GUI or CLI
italic text Provides emphasis
Identifies variables
Identifies paths and Internet addresses
Identifies document titles
code text Identifies CLI output
Identifies syntax examples
For readability, command names in the command titles and in the narrative portions of this guide are
presented in mixed letter case, for example, switchShow. In examples, command letter case is all
lowercase.