Converged Enhanced Ethernet Administrator's Guide v6.4.0 (53-1001761-01, June 2010)

110 Converged Enhanced Ethernet Administrator’s Guide
53-1001761-01
Converged Enhanced Ethernet map configuration
9
DRAFT: BROCADE CONFIDENTIAL
Applying a CEE provisioning map to an interface
Perform the following steps from Privileged EXEC mode apply a CEE provisioning map.
1. Enter global configuration mode.
switch#configure terminal
2. Specify the 10-gigabit Ethernet interface. In this example, 0/2 is used.
switch(config)#interface tengigabitethernet 0/2
3. Apply the CEE map on the interface. In this example, the CEE map name ‘test’ is used.
switch(conf-if-te-0/2)#cee test
Example of applying the CEE provisioning map on an interface.
switch:root>cmsh
switch>enable
switch#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)#interface tengigabitethernet 0/2
switch(conf-if-te-0/2)#cee test
switch(conf-if-te-0/2)#exit
switch(config)#end
4. Enter the copy command to save the running-config file to the startup-config file.
switch#copy running-config startup-config
Verifying the CEE maps
Perform the following steps from Privileged EXEC mode to verify the CEE map.
1. Enter global configuration mode.
switch#configure terminal
2. Verify the CEE map provisioning for a specified name.
switch(config)#show cee maps name