HP StorageWorks Fabric OS 6.x administrator guide (5697-7344, March 2008)

Fabric OS 6.x administrator guide 295
Viewing equipment status
You can display status for fans, power supply, and temperature.
NOTE: The number of fans, power supplies, and temperature sensors depends on the switch type. For
detailed specifications on these components, refer to the switch hardware reference manual. The specific
output from the status commands varies depending on the switch type.
To display the status of the fans:
1. Connect to the switch and log in as admin.
2. Enter the fanShow command:
switch:admin> fanshow
Fan 1 is OK speed is 7010 RPM
Fan 2 is OK speed is 7180 RPM
Fan 3 is OK speed is 7068 RPM
Fan 4 is OK speed is 7116 RPM
Fan 5 is OK speed is 7155 RPM
Fan 6 is OK speed is 7001 RPM
switch:admin>
The possible status values are:
• OK—Fan is functioning correctly.
• Absent—Fan is not present.
• Below minimum—Fan is present but rotating too slowly or stopped.
• Above minimum—Fan is rotating too quickly.
• Unknown—Unknown fan unit installed.
• FAULTY—Fan has exceeded hardware tolerance.
To display the status of a power supply:
1. Connect to the switch and log in as admin.
2. Enter the psShow command:
switch:admin> psshow
Power Supply #1 is OK
0335,FF2Z0007161,60-0000739-02, B,,DCJ3002-01P, B,FF2Z0007161
Power Supply #2 is faulty
0335,FF2Z0007176,60-0000739-02, B,,DCJ3002-01P, B,FF2Z0007176
switch:admin>
The possible status values are:
• OK—Power supply functioning correctly.
• Absent—Power supply not present.
• Unknown—Unknown power supply unit installed.
• Predicting failure—Power supply is present but predicting failure.
• FAULTY—Power supply is present but faulty (no power cable, power switch turned off, fuse blown, or
other internal error).
To display temperature status:
1. Connect to the switch and log in as admin.