HP StorageWorks Fabric OS 6.x administrator guide (5697-7344, March 2008)

Fabric OS 6.x administrator guide 33
The following example shows how to set up more than one NTP server using a DNS name:
switch:admin> tsclockserver "10.32.170.1;10.32.170.2;ntp.localdomain.net"
Updating Clock Server configuration...done.
Updated with the NTP servers
Changes to the clock server value on the principal or primary FCS switch are
propagated to all switches in the fabric.
Customizing switch names
Switches can be identified by IP address, Domain ID, World Wide Name (WWN), or by customized
switch names that are unique and meaningful.
Switch names can be from 1 to 15 characters long, must begin with a letter, and can contain letters,
numbers, or the underscore character. It is not necessary to use quotation marks.
NOTE: Changing the switch name causes a domain address format RSCN (registered state change
notification) to be issued and may be disruptive to the fabric.
To customize the switch name:
1. Open a Telnet session for each logical switch and enter the switchName command.
2. Connect to the switch and log in using an admin account.
3. Enter the switchName command, using the following syntax:
switchname "newname"
where newname is the new name for the switch.
4. Record the new switch name for future reference.
5. Record the new switch name for the second domain for future reference.
Working with Domain IDs
Although Domain IDs are assigned dynamically when a switch is enabled, you can reset them manually so
that you can control the ID number or resolve a Domain ID conflict when you merge fabrics.
If a switch has a Domain ID when it is enabled, and that Domain ID conflicts with a switch in the fabric, the
conflict is automatically resolved. The process can take several seconds, during which time traffic is
delayed.
The default Domain ID for HP switches is 1.
NOTE: Do not use Domain ID 0. The use of this Domain ID can cause the switch to reboot continuously.
Avoid changing the Domain ID on the FCS in secure mode. To minimize down time, change the Domain
IDs on the other switches in the fabric.
To display Domain IDs:
1. Connect to a switch and log in as admin.
2. Enter the fabricShow command.
Fabric information is displayed, including the Domain ID (D_ID)
switch:admin> fabricshow
Switch ID Worldwide Name Enet IP Addr FC IP Addr Name
-------------------------------------------------------------------------
64: fffc40 10:00:00:60:69:00:06:56 192.168.64.59 192.168.65.59 "sw5"
65: fffc41 10:00:00:60:69:00:02:0b 192.168.64.180 192.168.65.180 >"sw180"
66: fffc42 10:00:00:60:69:00:05:91 192.168.64.60 192.168.65.60 "sw60"
67: fffc43 10:00:00:60:69:10:60:1f 192.168.64.187 0.0.0.0 "sw187"