HP StorageWorks Fabric OS 6.x administrator guide (5697-7344, March 2008)

462 Configuring and monitoring FCIP extension services
Channel ISLs implemented through the FC-FC Routing Service (FRS) rather than FCIP. FC fastwrite is
supported in Fabric OS 5.3.x and later.
Figure 43 Typical network topology for FC fastwrite
Platforms and OS requirements for FC fastwrite
Fabric OS supports FC fastwrite between two 400 Multi-protocol Router or two 4/256 SAN Directors with
FR4-18i blades connected by a Fibre Channel network. FC fastwrite is a new feature beginning with Fabric
OS release 5.3.0. There is no backwards compatibility with previous releases. Fabric OS 5.3.0 or later is
required in the switches/blades at both ends of the FC fastwrite flow to enable this feature.
NOTE: FC fastwrite and FCIP tunnels cannot be used on the same 400 Multi-protocol Router or FR4-18i
blade.
Constraints for FC fastwrite
Consider the following constraints when configuring FC fastwrite.
• FC fastwrite disables the local Ethernet ports (ge0 and ge1), making it impossible to configure FC
fastwrite and FCIP tunnels on the same 400 Multi-protocol Router or FR4-18i blade.
• FC fastwrite does not work in FICON environments.
• FC fastwrite flows may be routed to another 400 Multi-protocol Router or FR4-18i blade on the FC
network. This 400 Multi-protocol Router or FR4-18i blade may have active FCIP tunnels over an IP
network. FC fastwrite flows may be passed through the FCIP tunnel, but only if the FCIP fastwrite option
is disabled on the tunnel.
• FC fastwrite does not support loop device configurations for more than one device.
How FC fastwrite works
FC fastwrite eliminates the latency inherent in sending Transfer Ready back to the initiator when writing
data across ISLs to geographically distant target devices. FC fastwrite provides a proxy target (PT) local to
the initiator host, and a proxy initiator (PI) local to the target storage device. Figure 44 on page 463 shows
how FC fastwrite works.
1. The initiator sends a write command.
2. The PT responds with a Transfer Ready, enabling the host to send more data.
3. The target device processes the write command, and sends a Transfer Ready to solicit more data. The PI
intercepts the Transfer Ready, and begins sending data received from the host.
400 MP Router400 MP Router