HP StorageWorks Fabric OS 6.x administrator guide (5697-7344, March 2008)

474 Configuring the PID format
Before changing the PID format, determine if host reboots will be necessary. The section ”Host reboots” on
page 468 summarizes the situations that may require a reboot.
switch:admin> switchdisable
switch:admin> configure
Configure...
Fabric parameters (yes, y, no, n): [no] y
Domain: (1..239) [1]
BB credit: (1..27) [16]
R_A_TOV: (4000..120000) [10000]
E_D_TOV: (1000..5000) [2000]
WAN_TOV: (1000..120000) [0]
Data field size: (256..2112) [2112]
Sequence Level Switching: (0..1) [0]
Disable Device Probing: (0..1) [0]
Suppress Class F Traffic: (0..1) [0]
SYNC IO mode: (0..1) [0]
Switch PID Address Mode: (0..2) [1] < Set mode number here.
Per-frame Route Priority: (0..1) [0]
Long Distance Fabric: (0..1) [0]
Converting port number to area ID
Except for the following cases, the area ID is equal to the port number:
• When you perform a port swap operation.
• When you enable Extended Edge (also known as “displaced PID”) PID on the director.
If you are using Extended Edge PID format (for example, the 4/256 SAN Director with configuration option
5) and would like to map the output of the port number to the area ID, use the following formula (for ports
0–127):
a = (p + 16) % 128
where:
a is the area, p is the port number, % is the modulus (or remainder)
When the port number is greater than or equal to 128, the area ID and port number are the same.
Figure 45 shows a 4/256 SAN Director with Extended Edge PID.
0 p 128<≤