HP Designjet 3D Removal System - Introductory Information: English

9
Red flashing process
error LED with cycle
length LEDs as shown:
Verify that the drain hose is not clogged.
Verify that there are no kinks in the drain hoses.
Make sure the system is at least 20 cm (8 in.) above the drain hose dis-
charge.
Make sure that no section of the drain hose is higher than the drain
hose discharge.
Power cycle the ON/Off switch at the back of the system to reset. Call
Customer Service if the problem persists.
Red flashing LED with
progress LEDs other
than shown above.
Power cycle the ON/Off switch at the back of the system to reset. Call
Customer Service if the problem persists.
Problem Recommendation