HP Designjet 3D Removal System - User's Guide: English

18 Chapter 8 System Specifications
8 System Specifications
Physical specifications
Facility specifications
Power specifications
Ecological specifications
This product complies with European Union WEEE and RoHS Directives.
For the up-to-date ecological specifications of your HP Designjet 3D Removal System, please go
to http://www.hp.com/ and search for “ecological specifications”.
Height 43.85 cm (17.25 in.)
Width 48.33 cm (18.24 in.)
Depth 43.18 cm (17.00 in.)
Weight 16.40 kg (36 lbs.)
Installation Location Stable level surface capable of holding 36 kg (80 lbs.)
Power Requirements A grounded electrical outlet (220–240V~ 9A 50 Hz 1200W)
located within 2 M (5 ft.) of the system.
Do not use an extension cord or a power strip, using these can
possibly cause intermittent power issues.
Drain Requirements The system must be located at least 20 cm (8 in.) higher than the
wastewater drain.
The drain facility must accept a drain pH level between 6.5 and
10.0.
The drain must accept a wastewater temperature of at least 75°C
(167°F) .
Water Requirements A connection to a water source with a 3/4 in. hose thread.
The water source temperature should be ≥15 ° C ( 59 ° F) .
The water pressure must be between 0.5 bars and 10 bars (7.25 psi
and 145 psi).
The water source hardness should be ≤300 ppm.
Source (nominal) 220–240V~ 9A 50 Hz 1200W
System Specifications