HP LF Printing Knowledge Center Calibrate my printer Printer: HP Designjet Z2100 series Software: HP raster driver Operating System: Mac OS X
The color calibration must be performed whenever: 1. A printhead is changed 2. A new combination of paper type and print mode is loaded which has not been previously calibrated with the current set of printheads. 3. The environmental conditions change (for example, temperature or humidity) 4. You notice deterioration in the quality of your prints or a large amount of printing has been done since the last calibration.
4. You will see the calibration information for different paper types. Select the media that is loaded on the printer and click Continue. 5. A calibration test chart is printed, which contains patches of each ink used in your printer. The printer will print and measure this linearization target and calculate the necessary correction factors to apply for consistent color printing on the paper type. It also calculates the maximum amount of each ink that can be applied to the paper.
6. Once the printer calibration is complete, click Done.
For more information on HP Designjet products www.hp.com/go/designjet © 2006 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein.
